Delta Electronics AC Drive VFD-F Series Especificaciones descargar pdf (Pagina 103)

Chapter 5 Parameters|VFD-S Series

5-46 Revision August 2008, SE09, SW V2.61

d29 M0: 0: RUN 1: STOP, M1: no function, Direction is controlled by keypad

RUN/STOP

M0 "Open": Stop, "Close": Run

M1 No Function

GND

4-09 Line Start Lockout

Factory Setting: d0

Settings d0 Disable

d1 Enable

 When enabled, the AC drive will not start when powered up with run commands applied. To

start in Line Start Lockout mode, the AC drive must see the run command go from stop to run

after power up. When Line Start Lockout is disable (also known as Auto-Start), the drive will

start when powered-up with run commands applied.

4-10 Up/Down Mode

Factory Setting: d0

Settings d0 Based on accel/decel time

d1 up frequency according to constant speed, down frequency

according to deceleration time

d2 up frequency according to acceleration time, down frequency

according to constant speed

d3 Constant speed

4-11

Accel/Decel Rate of Change of UP/DOWN Operation

with Constant Speed

Unit: 5

Settings d0 to d1000 Hz/sec Factory Setting: d1

 This parameter is used to set the acceleration/deceleration speed mode when multi-function

terminal is set to up/down frequency. (Pr. 4-04 ~ Pr.4-08, function d15, d16)

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 184 185

Sin comentarios

Delta Electronics AC Drive VFD-F Series Especificaciones Pagina 103