Delta Electronics TP06 Manual de usuario descargar pdf (Pagina 30)

Alignment and Adjustments

1-28 Samsung Electronics

Mute

S.STD

1-8 Convergence Adjustment

1-8-1 Convergence Adjustment

Special Notes

✏ A sensor is attached on the center of each side of the Convergence Mode pattern

(see figure below). The sensors are required for normal Perfect Focus function.

✏ Use a screen jig to do the convergence adjustments correctly (Especially, perform

correct convergence adjustments on the center of each side where a sensor is located.)

✏ Do the convergence adjustments correctly. Otherwise, any Perfect Focus error can

happen.

1. Warm up the TV for a least 30 minutes.

2. Input an PAL Signal.(Use an antenna or AV source.)

Make sure that deflection yoke are properly adjusted so that the center of

Green, Red, Blue pattern is aligned on the center of screen jig.

3. Enter the Convergence Mode by Pressing the remote control keys in the following sequence:

If OSD displayed as shown in figure below, press the key to exit.

Then, redo step 3 to enter the Convergence Mode.

After entering the Convergence Mode, Stand by for about five seconds

before doing the adjustments.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 72 73

Sin comentarios

Delta Electronics TP06 Manual de usuario Pagina 30