Delta-electronics ASDA-B Series Manual de usuario Pagina 170

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 321
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 169
Chapter 7 Servo Parameters|ASDA-B Series
Revision January, 2009 7-17
Others
Control
Mode
Parameter Name Function Default Unit
P S T
P1-32 LSTP Motor Stop Mode Selection 0 N/A
{ { {
P1-37 GDR
Ratio of Load Inertia to Servo Motor
Inertia
10
0.1
times
{ { {
P1-52 RES1 Regenerative Resistor Value 40 Ohm
{ { {
P1-53 RES2 Regenerative Resistor Capacity 60 Watt
{ { {
P2-08
PCTL
Special Factory Setting
0 N/A
{ { {
P2-30
INH
Auxiliary Function
0 N/A
{ { {
P2-34 SDEV Overspeed Warning Condition 5000 rpm
{
P2-35 PDEV Excessive Error Warning Condition 3000 10pls
{
P2-36 OVL Overload Protection Level 100 %
{ { {
P2-37 OVW Output Overload Warning Level 50% N/A
{ { {
P2-38 GBIT Special Function 0 N/A
{ { {
Explanation of symbols (marked after parameter)
() Read-only register.
() Parameter cannot be set when Servo On (when the servo drive is enabled).
() Parameter is effective only after the servo drive is restarted (after switching power off and on).
() Parameter setting values are not retained when power is off.
Vista de pagina 169
1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 320 321

Comentarios a estos manuales

Sin comentarios