Delta Electronics TP08 Manual de usuario descargar pdf (Pagina 53)

1 TPEditor Operation

1-51

the button object will not show on the screen, but the function of the button object is still effective when

executing.

Step 9. After complete all settings, click OK button to finish and the button will be used as it is configured.

Multi-Sate Button: After pressing this button, TP series will send the signal to the corresponding PLC contacts

or registers immediately. The signal could cycle from S0

S1 S2 … S0 or cycle from

… S2 S1 S0. The number of the state will vary by unit. When Data Length is Value,

the number of Total States could be up to 256. When Data Length is LSB, the number of Total States could be

up to 16. When Data Length is Bit, the number of Total States could be could be up to 2. If Bit is selected, the

Current State could be either 0 or 1. If LSB is selected, the Current State could be 0, 1, 2, 4, 8, and 16. If Value

is selected, the Current State could be 1, 2, 3, 4, 5, 6…256. The signal will cycle according to the set Current

State (Figure 1-90).

Figure 1-90

Input Value Button: When this button is pressed, TP series will display the system built-in input value table on

the screen. The users can use function keys or command keys to input the value. When Enter key is pressed,

the input value will be sent from TP series to the corresponding PLC register (Figure 1-91).

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 99 100

Sin comentarios

Delta Electronics TP08 Manual de usuario Pagina 53