Delta Electronics TP08 Manual de usuario descargar pdf (Pagina 69)

1 TPEditor Operation

1-67

Figure 1-119

Step 2. Then, Page Jump Condition Setting tab will display on the screen. The users can select the Refer

Device as Bit (Figure 1-120) or Value (Figure 1-121) device in Condition Setting option. Max. 20 pages

could be set.

Figure 1-120 Figure 1-121

Step 3. After entering the device name and clicking

, the Refer Device tab will open (Figure1-122). In the

Refer Device tab, the users can enter device name, set device number and communication address.

The device name could be X, Y, M, S, D, C, and T and the device number is indicated in decimal

format. When entering into the Refer Device tab, the users should select the desired device type (Bit or

Value) first. If the Refer Device is set to Bit, the available device could be X, Y, M, S, C, T. If the Refer

Device is set to Value, the available device could be T, C, D. The users could click

to select the

necessary Device Name. If the connected controller is AC motor drive (Inverter), it does not need to

check the Device Name. The symbol $ will show after the Device Name to represent the absolute

address of AC motor drive. What the users need to do is to input absolute address in the field of Device

Number. For example, if the register is D10, the communication address is used to determine which

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 99 100

Sin comentarios

Delta Electronics TP08 Manual de usuario Pagina 69