Delta Electronics TP08 Manual de usuario descargar pdf (Pagina 44)

1 TPEditor Operation

1-42

Step 2. Double-click the square by using the mouse, a Dynamic Bitmap Setting tab will appear to let the

users select the Refer Device as Bit or Value (Figure 1-75).

Figure 1-75

Figure 1-76

Step 3. When the Refer Device is set to Value, the Display Sequence could be either “From Max to Min” or

“From Min to Max” (Figure 1-76).

Step 4. The Dynamic Bitmap Setting tab is similar to Word Lamp Setting tab. Some options are even the same,

such as Refer Device, Value Type and Value Length, etc. But in Dynamic Bitmap Setting tab, the Total

States could be set up to 255, i.e. from 0 to 254. After double-clicking the selected Dynamic Bitmap

object, a Open dialog box will appear and the users could select the desired display picture (the picture

must be a BMP file). The state of the Dynamic Bitmap object changes, and the corresponding display

picture changes as well. Each state should have its corresponding setting range. The option of “Device

Value >= Range Value” is used to set the corresponding setting range. For example, suppose that

Display Sequence is set to “From Max to Min”, if the setting of “Device Value >= Range Value” is set to

300 for Current State 0, and the setting of “Device Value >= Range Value” is set to 100 for Current

State 1, when the Device Value is equal to or greater than 300, the picture of Current State 0 will show

on the screen; when the Device Value is equal to or greater than 100, the picture of Current 1 will show

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 99 100

Sin comentarios

Delta Electronics TP08 Manual de usuario Pagina 44