Delta Electronics TP08 Manual de usuario descargar pdf (Pagina 70)

1 TPEditor Operation

1-68

PLC or AC motor drive will be communicated with, i.e. the communication address of the connected

PLC or AC motor drive. TP Port is used to set the communication port that used to connect to the

monitored equipment and the available selection is COM1 (RS-232) or COM2 (RS-485/RS-422). After

completing the settings, click OK button, and return to Page Jump Condition Setting tab (Figure 1-123).

Figure 1-122

Figure 1-123

Step 4. In Condition Setting option, when Bit is selected, it means that Refer Device is set to a contact and

ON/OFF Setting option will display for the users to set the contact to be ON or OFF by selecting Set

OFF or Set ON (Figure 1-124). However, If Value is selected, it means that Refer Device is set to a

value of a register and Value Setting option will display for the users to set the length and type of this

value, and the compare setting for this value (Figure 1-125). When the set conditions are satisfied, the

system will jump to the destination page (screen). The users could click

directly to switch to the

desired page. When there is only one edited page, 0 will show in the filed of Jump Page. In TPEditor,

the default display number of Jump Page is also 0.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 99 100

Sin comentarios

Delta Electronics TP08 Manual de usuario Pagina 70