
4
VFD-S Series
DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
4-1
CHAPTER 4 DIGITAL KEYPAD OPERATION
4.1 Description of Digital Keypad
This digital keypad includes two parts: Display panel and keypad. Display panel provides the
parameter display and shows operation status of the AC drive. Keypad provides programming
interface between users and AC drives.
RUN
FWD
REV
STOP
MIN. MAX.
RUN
STOP/RESET
MODE
PROG
DATA
LED indication
Light during RUN,
STOP, FWD and
REV operation.
Potentiometer for
frequency setting.
Could be the Master
Frequency input
by setting Pr.2-00.
Mode Key
Change between
different display
modes.
LED Display
Indicate frequency, motor
parameter setting value
and alarm contents.
RUN Key
Start inverter drive operation.
STOP/RESET Key
Stop inverter drive operation
and reset the inverter after
faults occurred.
PROG/DATA Key
Set the different parameters
and enter information.
UP and DOWN Key
Sets the parameter number
or changes the numerical
data such as the freq.
reference.
MODE
Mode
By pressing the “mode” key repetitively, the display will show status at the AC drive
such as the reference frequency, output frequency, and output current.
PROG
DATA
PROG/ DATA
Pressing the “PROG/DATA” key will store entered data or can show factory stored
data.
RUN
Run
Start the AC drive operation. This key has no function when the drive is controlled
by the External Control Terminals.
STOP/RESET
Stop / Reset
Stop AC drive operation. If the drive stops due to a fault, correct the fault first, then
press this key to reset the drive.
Up / Down
Press the “Up” or “Down” keys momentarily to change parameter settings. These
keys may also be used to scroll through different operating values or parameters.
Pressing the “Up” or “Down” key momentarily, will change the parameter settings in
single-unit increments. To quickly run through the range of settings, press down
and hold the key.
Comentarios a estos manuales