Delta-electronics AC Servo Drive ASDA-B Manual de usuario descargar pdf (Pagina 119)

Chapter 6 Control Modes of Operation|ASDA-B Series

6-4 Revision February 2008, Doc. Name: 2006PDD23000009

6.2.3 Pulse Inhibit Input Function (INHP)

INHP is activated via digital inputs (Please refer to parameter P2-10 ~ P2-15 and DI INHP(07) in Table

7.A).When the drive is in position mode, if INHP is activated, the external pulse input command is not

valid and the motor will stop.

Pulse

command

INHP

OFF

6.2.4 Electronic Gear Ratio

Relevant parameters:

P1 - 15▲

GR4 Electronic Gear Ratio (2nd Numerator) (N2) Communication Addr.: 010FH

Default: 1 Related Section:

Applicable Control Mode: P Section 6.2.4, P1-44, P1-45

Unit: pulse DI GNUM0(11) in Table 7.A

Range: 1 ~ 32767

Settings:

The electronic gear numerator value can be set via external DI signal (refer to Table 7.A).

DI Name DI Status Selected Electronic Gear

Not select (Note 1) P1-44, P1-45

0 P1-44, P1-45

GNUM0

1 P1-44, P1-45

NOTE

1) DI signal can be selected by parameter P2-10 to P2-15 and Table 7.A. If uses only need to

use one group of electronic gear, it allows users not to select GNUM0.

P1 - 44▲

GR1 Electronic Gear Ratio (1st Numerator) (N1) Communication Addr.: 012CH

Default: 1 Related Section:

Applicable Control Mode: P Section 6.2.4, P1-15, P1-45

Unit: pulse DI GNUM0(11) in Table 7.A

Range: 1 ~ 32767

Settings:

The electronic gear numerator value can be set via external DI signal (refer to Table 7.A).

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 320 321

Sin comentarios

Delta-electronics AC Servo Drive ASDA-B Manual de usuario Pagina 119